piaggio x8 150 cdi immobiliser bypass 2005 2008 Yamaha WR200 It has 100mm mounting points

It has 100mm mounting points and 2 spade connectors with 2 HT leads

This set of steering bearings are taper roller style and have been manufactured to replace the original head stock bearings on a YZ100 for the years and models shown above

If you are having problems with your Piaggio X9 125 liquid cooled scooters immobiliser or have a CDI fault (no spark

ACI603 & ACI604 or if you have an EFI Technology unit it will replace the following CDI stamped units AC2i

5 ohm (primary) coil so you may need to remove the resistor to run these coils

piaggio x8 150 cdi immobiliser bypass 2005 2008 Yamaha WR200 It has 100mm mounting pointsBrand new CDI immobiliser chip key bypass to fit: Piaggio X8 150 (2005 2008). This replaces MAGNETI MARELLI ACI600 ACI601 ACI602 ACI603 ACI604 units or EFI Technology AC2i AC3i AC5i AC8i units. Please note other CDI Immobilisers may look similar but the original CDI must have one of the AC numbers mentioned above stamped on it for this to fit. 4T Liquid models. Not suitable for Air cooled, fuel injection or euro 3 spec models. Simply plugs straight in