End of Material Sensor (Electro-mechanical) Connection Hardware & Accessories (Emitter: 15 mA max

(Emitter: 15 mA max

30' and 100' lengths are available

or PRO Servo or Hydraulic - 6" range

PLEASE NOTE:

It detects material run out

End of Material Sensor (Electro-mechanical) Connection Hardware & Accessories (Emitter: 15 mA maxThe End of Material sensor is designed for metal stamping applications. It detects material run out, and prevents pulling of the coil end through the feeder or straightener. It also keeps the press from running without coil stock. The sensor is typically installed so that the arm rides on the material. When the material runs out, the arm drops onto the insulated pin below it, generating a ground signal that is detected by the die protection